CS Unitec Plate Cutter, Carbide Tipped, 1-7/8" dia., 12" usable length, 14-3/4" overall length, 1-1/4" x 7" hub thread size

CS Unitec Plate Cutter, Carbide Tipped, 1-7/8" dia., 12" usable length, 14-3/4" overall length, 1-1/4" x 7" hub thread size Product Guide

This plate cutter is a specialized accessory designed for cutting steel plates, embedded rebar, and wire mesh encountered during concrete drilling operations. Its carbide-tipped cutting surface and precise dimensions make it suitable for integration with compatible core drilling equipment, addressing the challenge of penetrating composite materials without frequent tool changes.

In practical use, this plate cutter is often employed when drilling through reinforced concrete where steel reinforcement or mesh is present. It can be attached to compatible core drills with a matching hub thread size. Rental users benefit from its durable carbide tip that tolerates rough site conditions. The cutter is suitable for both wet or dry cutting applications, though wet use with a controlled water supply often helps reduce dust and tooling wear.

Where This Is Used

• Cutting steel plates embedded within concrete slabs or structures
• Penetrating embedded rebar and wire mesh during core drilling tasks
• Industrial and construction projects requiring combined concrete and steel material removal

Key Details

Selection Notes

From a selection standpoint, confirm that the core drill equipment supports this size and thread pattern to ensure secure mounting. The carbide tip design is suitable for moderately reinforced steel encountered in typical structural applications but verify that the plate thickness and rebar diameter do not exceed the cutter's effective capacity. The usable cutting length of 12" allows for deeper cuts into embedded steel layers. Wet cutting may extend cutter life and reduce dust; however, dry use is also feasible depending on site constraints.

Setup Planning Notes

Before use, inspect the plate cutter for any carbide tip wear or damage. Confirm that drilling equipment accommodates the 1-1/4" x 7 hub thread size securely to avoid slippage during operation. When planning wet cutting, organize water supply lines to provide a small, steady flow to the cutting surface without flooding, helping control dust and clear slurry. Ensure compatibility with the drill's rotation speed and torque to prevent premature cutter wear. Post-use, clean the cutter to remove concrete slurry or debris that may accumulate during operation.