CS Unitec Plate Cutter, Carbide Tipped, 2" dia., 12" usable length, 14-3/4" overall length, 1-1/4" x 7" hub thread size

CS Unitec Plate Cutter, Carbide Tipped, 2" dia., 12" usable length, 14-3/4" overall length, 1-1/4" x 7" hub thread size Product Guide

The CS Unitec Plate Cutter is a carbide-tipped cutting tool designed to be mounted on a compatible core drill for cutting through steel plates, embedded rebar, and wire mesh commonly found within concrete structures. It solves the problem of efficiently cutting metal components that intersect with concrete, allowing combined drilling and metal cutting without switching tools.

This type of plate cutter is typically used in concrete renovation, demolition, and structural modification projects where reinforced concrete slabs include metal reinforcements that must be penetrated cleanly. It is suitable for both wet and dry use, with a small amount of water recommended for wet cutting to reduce dust and improve bit life. The cutter's carbide tipping provides durability and wear resistance under rough field conditions, making it well suited for demanding industrial job sites.

Where This Is Used

• Cutting steel plates embedded within concrete slabs during structural modifications
• Penetrating rebar and wire mesh reinforcement for downstream mechanical or electrical installations
• Preparing openings in composite concrete-steel assemblies in renovation or bridge repair projects

Key Details

Selection Notes

From a selection standpoint, it is important to match the plate cutter diameter to the core drill and to the size of the metal to be cut. The 2" diameter cutter is suitable for moderate steel plate thicknesses and typical rebar sizes found in reinforced concrete. Confirm the hub thread compatibility with the drill machine to ensure proper mounting. Consider whether wet cutting can be accommodated on site to extend cutter life and control dust. For jobs with combined concrete core drilling and steel cutting, this tool avoids the need to change bits between operations.

Plate Cutter Setup Notes

When setting up this plate cutter, confirm it is securely mounted on a core drill with the specified 1-1/4" x 7 hub thread size. For wet cutting, arrange a water supply to provide a small and steady flow near the cutting surface to minimize dust and heat buildup. Verify the cutter shows no excessive wear or damage before use. Plan for accessible clearance around the drill site to accommodate the tool’s 14-3/4" overall length. After use, clean the cutter to remove concrete slurry, steel dust, and debris to maintain cutting effectiveness. Routine inspection of the carbide tips will help determine when replacement is needed for consistent cutting performance.