CS Unitec Plate Cutter, Carbide Tipped, 4" dia., 12" usable length, 14-3/4" overall length, 1-1/4" x 7" hub thread size

CS Unitec Plate Cutter, Carbide Tipped, 4" dia., 12" usable length, 14-3/4" overall length, 1-1/4" x 7" hub thread size Product Guide

The CS Unitec Plate Cutter is a carbide-tipped cutting accessory designed for use in core drilling equipment. It is specifically made to cut through steel plates, embedded rebar, and wire mesh often encountered during concrete core drilling. This tool addresses the challenge of penetrating mixed material components, providing effective steel cutting capability within drilling operations.

Typically, this plate cutter is paired with compatible core drills to enable combined concrete and steel cutting in one operation. Its robust carbide tip ensures durability under rough usage conditions. In field applications, it can be run wet with water to reduce dust and cool the bit or dry when water supply is limited. The cutter’s thread size of 1-1/4" x 7 allows connection to standard drilling equipment hubs, facilitating straightforward tool changes and compatibility across similar core drill platforms.

Where This Is Used

• Construction sites requiring through-concrete drilling with embedded steel cutting
• Infrastructure repair jobs involving steel reinforcement removal or modification
• Industrial maintenance projects needing precise cuts through steel plates and wire mesh in concrete

Key Details

Selection Notes

Selecting this plate cutter depends largely on the diameter compatibility with the existing core drill and the job’s material conditions. The 4" diameter size suits moderate steel cutting alongside concrete cores. Confirm the drill’s hub threading matches 1-1/4" x 7 to avoid fitting issues. Consider whether wet cutting is feasible onsite since water use can prolong bit life and assist in dust control. For projects with predominantly steel components, a carbide-tipped cutter like this provides better wear resistance and cutting performance compared to standard masonry bits. The 12" usable length allows sufficient cutting depth through mixed material sections.

Setup Notes

Ensure the plate cutter is securely threaded into the core drill hub with the specified 1-1/4" x 7 thread size to maintain rigidity during operation. If wet cutting, arrange a controlled water feed to the drilling area to cool the bit and flush out debris while preventing excess slurry accumulation. Before starting the job, inspect the condition of the carbide tips for sharpness and integrity to optimize cutting efficiency. After use, clean the tool to remove concrete slurry and steel dust, allowing longer service life and consistent cutting performance. Because this cutter can be exposed to abrasive conditions, checking for wear and replacing it as needed will support ongoing reliability.