Marine Salvage Pillows

JOINT ZONE MARINE SALVAGE BAGS

FEATURES

• Joint Zone enclosed flotation bags have several important and distinctive characteristics.
• Due to the polyester fabric and its EVA/PVC copolymer coating, the material is very flexible and very easy to repair (with glue or a hairdryer with hot air)
• Joint Zone enclosed flotation bags are made of a very strong coated polyester fabric with a tensile strength of no less than 8,000 N/5 cm
• Joint Zone enclosed flotation bags have no sharp corners (they are rounded off and smooth), which makes these enclosed flotation bags more robust and less likely to be damaged
• Joint Zone enclosed flotation bags are lightweight! Up to 50% lighter than the competition's enclosed flotation bags, while the lift capacity is at least 10% higher
• The enclosed flotation bags require little maintenance and are very easy to clean
• Due to the high-strength polyester fabric type IV, the material with which the enclosed flotation bags are made has a puncture resistance of no less than 2,150 N (in contrast to many competing products that only reach 1,750 N)

TOP QUALITY MATERIAL

• EVA/PVC copolymer coated polyester fabric - high-strength and heavy-duty
• Fabric's tensile strength: 8,000 N/5 cm
• Puncture resistance: 2,150 N (in contrast to competitor's products, which often do not reach more than 1,750 N)
• Resistant to many chemicals
• High UV-resistance
• Very easy to repair (with glue or a hairdryer with hot air), unlike materials coated with PU or TPU
• Highly flexible and lightweight material
• Equipped with a ¾" stainless steel ball valve
• Equipped with pressure relief valves

Each Joint Zone lift bag is tested prior to shipping.
Custom Sizes available.
All Joint Zone lifting bags are IMCA D-016-AIRBAGS compliant.

SUBSALVE ENCLOSED FLOTATION BAGS

VERSATILE
When you need to float an object close to the surface, use SUBSALVE's pillow shaped Enclosed Flotation Bags in any position—upright or flat, outside or inside of structures— for vessel salvage, auto recovery, pipeline and cable installation and emergency flotation for ships, aircraft, submersibles and ROVs.

ADAPTIVE
Configure a multitude of rigging combinations.

• Use with a single pick point (shackle supplied on the bottom of the bag).
• Invert to use the multiple stainless steel rings on the top of the bag. *Note: Using the multiple stainless steel rings on the top of the bag for load carrying is not recommended. These should be used for securing position only. EFB-200 does not have rings at the top. Only 1 ring at the bottom.

Fabric

• Urethane-coated nylon—high-strength and heavy-duty
• Superior abrasion resistance
• Resistant to most petro-chemicals
• UV-resistant
• Low maintenance requirements and easy to clean
• RF welded seams Lifting Harness
• Heavy nylon lift harness built into the body of the lift bag
• Safe working ratio of 6:1

Safe and easy of use

• Equipped with all necessary hardware—ready for immediate use
• 3/4” NPT inflation/deflation port
• Stainless steel quick disconnect for inflation
• Pressure relief valves: set to release at 2.5 psi above ambient pressure
• Enough pressure relief vales are installed in each bag to allow expanding to vent should a free ascent occur.

Each SUBSALVE USA lift bag is tested prior to shipping.
Custom Sizes available.
All Subsalve USA products are compliant with IMCA D-016-AIRBAGS, ABS, U.S. Department of Defense Standards.