Sava 510395 Protective Rubber Sleeve for Pipe Plugs 14" to 24"

Sava 510395 Protective Rubber Sleeve for Pipe Plugs 14" to 24" Product Guide

Pipe Plug Selection Notes

From a selection standpoint, this protective sleeve fits pipe plugs with nominal diameters ranging from 14 to 24 inches. It is designed to reduce premature wear and abrasion on plugs used in industrial environments where pipe surfaces may be rough or have debris. When selecting a sleeve, confirm that the plug size falls within this size range to confirm correct fit and protection. The sleeve is intended to supplement pipe plugs where additional abrasion resistance is necessary but does not alter the plug’s sealing or pressure ratings.

Pipe Plug Setup And Maintenance Planning

Before inserting the sleeve onto the pipe plug, inspect it for cuts, tears, or other damage that could compromise protection. Install the sleeve carefully to cover the areas most susceptible to abrasion from rough pipe interiors or installation procedures. During use, verify that the sleeve remains properly positioned and free from excessive wear. After removal, clean the sleeve and the pipe plug to remove sediment and inspect both for any damage.