Sava 527496 Protective Rubber Sleeve for Pipe Plugs 24" to 48"

Sava 527496 Protective Rubber Sleeve for Pipe Plugs 24" to 48" Product Guide

Protective Sleeve Selection Notes

This protective rubber sleeve is sized to fit pipe plugs ranging from 24 to 48 inches in diameter. From a selection standpoint, it is important to confirm that the sleeve corresponds exactly to the nominal pipe plug diameter in use, as correct fit confirms adequate coverage and protection. The sleeve adds a supplemental rubber layer to reduce premature wear or abrasion commonly encountered on inflatable pipe plugs during insertion, use, or retrieval in rough or abrasive pipe conditions.

Installation and Setup Planning

Before installing the sleeve, inspect the pipe plug surface for existing damage or deterioration to verify sleeve effectiveness. Plan for careful sleeve placement to avoid wrinkles or folds that could compromise the seal or cause uneven wear. After installation, monitor the plug during use to track any abrasion or damage through the sleeve. Clean and store the sleeve properly after use to prevent cracking or deformation, which could reduce protection on subsequent deployments.