Sava 60616 Z8 8" Single-Size Commercial Series Inflatable Pipe Plug

Sava 60616 Z8 8" Single-Size Commercial Series Inflatable Pipe Plug Product Guide

Pipe Plug Selection Notes

The Sava 60616 Z8 fits nominal 8-inch pipes and is part of the Commercial Series of inflatable plugs made of NR-SBR rubber reinforced with Kevlar tire cording. When selecting this plug, confirm the pipe diameter matches its single-size designation to confirm correct seating and sealing. The plug’s rated working inflation pressure and backpressure limits are important to verify against job site conditions, especially since it is test-rated at three times its working pressure for safety assurance. For applications in buildings or factories where a shorter, lightweight plug is needed, this model is a considered choice.

Inflation And Blocking Planning

Before installation, inspect the plug thoroughly for any cuts, abrasions, or damage to the rubber surface as these can lead to premature failure. While inflating, use the standard tire valve to bring the plug to the specified working pressure and maintain that pressure throughout the job to sustain the seal. This plug’s compact and lightweight design means blocking or bracing should be planned according to the user manual to prevent displacement under pressure. Clean the pipe and verify the surface where the plug seals is free of debris or irregularities. Because it is constructed with synthetic rubber and Kevlar reinforcement, check chemical exposure and pipe temperature conditions to confirm compatibility with the NR-SBR composition before deploying the plug. After completion, deflate carefully and inspect before storage for later use.